If you’re experiencing an issue with your Camera Blinking Red, the notification LED can blink red. It’s a common problem that can be easily fixed at home, saving you time and money.
The first step is to check your batteries and memory card. If either one is low or full, you can simply replace it or format it to fix the problem.
Battery
When your camera blinks red it can be caused by a few different issues. One of the most common causes is a battery issue. You can easily fix this by keeping track of how often you replace the batteries and replacing them before they die out completely.
Another cause of the camera blinking red is a connection issue. This can be a problem with the internet, or the Sync Module, and can easily be solved by connecting the camera to the correct router or WiFi network.
Sometimes, a Blink Camera Blinking Red will flash red during setup, as it searches for a good connection to the Sync Module or the Internet. This is normal, and will stop after you have completed the setup process.
The camera blinks red after it detects motion with its infrared Camera Blinking Red. This is a normal feature of Blink cameras, and you can easily test it to see if it’s working properly.
Wi-Fi
If you’re trying to connect your Blink camera to the internet and the built-in LED starts blinking red, it could be for one of several reasons. Most often, it indicates a Wi-Fi issue.
To solve this, first check your router’s status to make sure it’s working and that there aren’t any local outages in your area. Then, move your Blink Camera Blinking Red closer to the router to ensure it has a strong signal.
This will help your Blink Camera Blinking Red to connect to the internet again. If that doesn’t work, try a hard reset of your camera to see if that fixes the problem.
A low battery can also cause the camera’s red LED to flash. If this is the case, it’s best to replace both AA batteries at once.
Sync Module
If your camera is blinking red, it means that there’s a problem with the Sync Module. This little device is responsible for integrating your Blink cameras and doorbell into one system.
The Sync Module connects to Wi-Fi, so you can use it to view and store video files from your cameras. It also lets you connect a USB flash drive for local storage of video.
It comes with a wall DC power supply, a USB-A to Micro-USB cable, and an instruction booklet.
You can factory reset your Sync Module by pressing the hard factory reset button with something small and thin (like a paper clip). The light should change from solid red to a blinking green/solid blue pattern within five seconds of pushing the button.
If you don’t see this pattern, try moving your camera closer to the Sync Module or getting a Wi-Fi extender to boost your signal. It should reach a range of around 23-30ft, depending on the router’s settings and where you place it.
Settings
When your Blink outdoor camera begins flashing red it could be for a number of reasons. There may be a problem with your WiFi connection or it could be an issue with your battery.
First, check your Wi-Fi connection by logging in to your Blink app on your smart device. If you see a live video stream, then everything should be okay.
Next, check your Sync Module by navigating to the settings icon of the camera in question and going to “Update.” If the blue bar shows up at three bars, then it means that both cameras are connected properly.
If you are still having issues, then try a power cycle and reset your camera. These are two fairly simple solutions that should get you back up and running in no time. If those don’t work, then contact Blink support and they can walk you through more troubleshooting steps. They should be able to offer some advice or even replace your camera.